SPECIFICATION:
Material: Aluminum. All mounting hardware is Stainless Steel
Finish: Plates are MIL-SPEC Type III Hard Anodized – Black
INCLUDED:
Qty 1 – Optic Plate
Qty 3 – 6-48 x .200 FH Plate Mounting Screws
Qty 3 – 4-40 x .345 FHB Holosun 407k / 507k , CHPWS EDC / EDC Enclosed Optic Mounting Screws
Qty 3 – Stainless Steel T-Nuts
Agency / Department Discount Program
DRY-FITTING DISCLAIMER:
At C&H Precision, our products are designed and manufactured to meet tight tolerances. Installation can be affected by variations in your plate, hardware, optic, and firearm tolerances. For safe installation and to prevent potential damage to any component, we advise dry-fitting all parts before a full installation. If any problems arise during this process, please reach out to our Customer Service via our contact portal.
IRON SIGHTS DISCLAIMER:
When making aftermarket firearm modifications, factory components can often become obsolete, particularly when mounting optics on the slide, whether through direct milling or using a plate. Achieving the correct height for low co-witness iron sights depends on factors such as the firearm type, mounting plate, optic, and slide cut. For assistance in determining the appropriate iron sight height for your specific setup, please contact our Customer Service team through our dedicated contact portal.
chester –
I had C&H mill AOS for Springfield EMP3. I put this plate on it because I did not want a rear iron sight. I used this plate to mount up a vortex defender CCW on the EMP3 and it now a tac driver. Note when you mill for the AOS on the EMP3 that plate will be an about 1/4 over the top of the back of the slide. I would like to see this plate made in the other footprints in the future, ARCO, RMR , etc. Looks good and a great product!
Lawrence Obrowski –
10 days and I still don’t have my order…….