The C&H Precision plates are designed, manufactured and shipped from our small family owned business in Coastal Georgia. Each plate is precision machined to the tightest tolerances on HAAS CNC machines and each plate goes through multiple quality checks before shipping to our customers.
Most of our plates feature a patented stainless steel T-Nut which provide an industry leading six to seven threads of engagement. Since all the mounting hardware is replaceable, if any mounting hardware is damaged it can be replaced without replacing the entire plate.
Thickness: V4 MIL / LEO Plates are .095″ to .099″ thick
Material: Plates are made from 6061 aluminum. All mounting hardware is Stainless Steel
Finish: Plates are MIL-SPEC Type III Hard Anodized – Black
Replaceable 416 Stainless Steel T-Posts for maximum thread engagement
Qty 1 – Optic Plate
Qty 2 – M4 Plate Mounting Screws
Qty 2 – 4-40 Optic Mounting Screws
Qty 2 – Patented 416 Stainless Steel T-Nuts
DISCLAIMER: This product is not manufactured, authorized, endorsed,
or warranted by GLOCK. GLOCK does not warrant or represent that
this product is compatible with GLOCK pistols
WILLIAM DALY (verified owner) –
These folks are AMAZING to work with. I had great counsel from one of their guys about ordering this plate. I was concerned about it setting the Trijicon RMR up to high…but, it was the more cost effective road to go down – AND – if I didn’t like it, they would credit the slide back to me if I did it in a reasonable time frame. Well, it does ride high as he had consulted me it would, and I made the decision to go ahead and have it milled about a month later. THEN – I messed up and didn’t communicate well on the credit for the plate that I sent back and they took care of me right away and gave me the credit for the plate. Wish I could put more business there way…but I only have so many guns!
Troy Douglass (verified owner) –
Didn’t fit my 43x slide. Couldn’t get it to set flush at the rear post. No amount of pushing was going to get it over the rear post. I’m not hammering it on, no need to be tight! Ordered a trijicon mount.
Chris Hewitt (verified owner) –
Absolutely perfect fit and finish.
David Crump (verified owner) –
The plate was really tight and would not go into the top of the Glock. I had to use a rubber mallet and tap it in. Holes lined up fine. The plate is designed to make the RMRcc sit above the slide. It makes the RMRcc sit way to high. If you want an RMRcc have the slide milled.
Nathan Turner (verified owner) –
Works great once i got it on ..very tight fit and the mounting holes were slightly outta place in the back but close enough to tap it in with a rubber mallet ..but it is a super snug fit an works great with the trijicon rmrcc