**THIS PLATE IS INCOMPATIBLE WITH THE NEWER SIG-LOK CUT. CLICK HERE TO SEE PICTURE.**
The C&H Precision plates are designed, manufactured and shipped from our small family owned business in Coastal Georgia. Each plate is precision machined to the tightest tolerances on HAAS CNC machines and each plate goes through multiple quality checks before shipping to our customers.
SPECIFICATION:
Material: Plates are made from Mild Grade steel. All mounting hardware is Stainless Steel
Finish: Plates are Electro Deposition Painted – Black
INCLUDED:
Qty 1 – Optic Plate
Qty 3 – M4 x 6MM M3H Plate Mounting Screws
Agency / Department Discount Program
DRY-FITTING DISCLAIMER:
At C&H Precision, our products are designed and manufactured to meet tight tolerances. Installation can be affected by variations in your plate, hardware, optic, and firearm tolerances. For safe installation and to prevent potential damage to any component, we advise dry-fitting all parts before a full installation. If any problems arise during this process, please reach out to our Customer Service via our contact portal.
IRON SIGHTS DISCLAIMER:
When making aftermarket firearm modifications, factory components can often become obsolete, particularly when mounting optics on the slide, whether through direct milling or using a plate. Achieving the correct height for low co-witness iron sights depends on factors such as the firearm type, mounting plate, optic, and slide cut. For assistance in determining the appropriate iron sight height for your specific setup, please contact our Customer Service team through our dedicated contact portal.
Perry –
Great product. Not quite five stars as needed a touch of a file. The ‘bump’ on plate bottom needed to fit into slot (at least in MY frame) was a ‘red pubic hair’ too wide. Wouldn’t allow the plate to fit flat. One touch of jewelers file and it was a perfect fit. Then shot of Cerakote to repair finish. Done.
Overall, I’m quite happy with it.
Logan –
It’s OK, honestly tolerances were not what I expected from a C&H product, and I have ~4-5 different plates. after tightening the acro cross-bolt to spec I can see through the gap between the plate and the optic below the cross-bolt.
This seems a bit like a lost opportunity to really lock the plate to the slide. If the tolerances were tight enough and the screw heads perfectly flush with the top of the plate when torqued to spec then the acro could have prevented those screws from backing out bit sitting on top of them, but instead there’s a gap big enough to see through… It works, but I’d hoped for more.